Dm / Cm 4100 Series Voice Activated Microphone Units - DIS CDS 4000 User Manual & Installation Manual

CDS 4000
number LOG2 and so forth. 10 consecutive
physical numbers are always updated upon
reception of a download message. Note observe the
restriction 1<=POS<=990 – POS and the following
9 positions all have to be within the conversion
table bounds. It is not possible to invalidate the
conversion table by giving two physical numbers

DM / CM 4100 Series Voice Activated microphone units

The DM / CM 4100 series of units function exactly
as the standard units, but only when they are in
MAN/AUT mode. If they are in VOICE
ACTIVATE mode, no messages will be sent about
Manual no. 4479, Printed in Denmark, 10/02
the same logical number - the MC4000 software
enforces the basic rule that all logical numbers in
the conversion table have to be different. The
interface card will respond to this message by
returning a Conversion Table Download
acknowledge message.
units switching on and off automatically controlled
by the sound level. The message is not sent from
the microphones to the central unit, so it is not
possible for the central unit to tell.
RS232 PROTOCOL
APPENDIX 1, 51