Operating Instructions; Battery Charging - Williams Sound Digi-Wave DLT-100 User Manual

Operating Instructions

Important! Before you begin:
Chairman Master unit must be on when setting up system. If no Chairman
Master is on, slave units will turn off in two minutes
Every group MUST HAVE ONLY ONE Chairman Master.
1. Battery should be charged initially for 12 hours.
2. To power on or off, press and hold power button for 2 secs.
3. Display shows setting saved in previous use.
4. Internal mic and speaker is active until microphone and earphones
are plugged in to the jacks. (Mic and Speaker will be de-activated
when external mic and earphone is plugged in).
5. Adjust volume by pressing volume + or – buttons. Volume level will be
displayed on LCD.
6. Talk button must be pressed with red light on to activate microphone.
Press talk again to disable microphone (red light will turn off).
7. To activate the voting feature (Chairman Master only), press and hold
the abs button. Red, Amber and Green LED's will illuminate. YES vote
tally will be on the right and No tally will be on the left of the display.
To deactivate voting, press and hold ABS button.

Battery Charging

1. This product uses rechargeable Lithium Polymer battery
2. To charge the battery in the DLT-100, use the supplied charger and
cable. Full charging time: approx. 5 hours
· Red LED flashes while charging.
· Green LED on continuously when battery is charged.
3. Battery Maintenance
· Charge the battery at room temperature
4. Do not charge the battery more than 12 hours continuously ( Optional
CHG 102 - 2-bay charger available ).
DLT-100 Digital Transceiver
MAN155D