GE GE100 User Manual page 20

Recalling Test Results and Average
The GE100 Blood Glucose Meter is able to automatically
and date. If your meter has stored 500 results, the newest test result will replace the oldest one. To
recall your test memory, start the meter without a test strip inserted.
1. Press the Main button to switch from the time mode to the Memory screen. You
will see the "MEM" symbol in the upper left corner of the display. When you press
the Down button, the latest result will be displayed. By pressing the
sequentially, previous test results will be shown in chronological order. You will see
the sequence number in the lower right corner and the year in the lower left
corner of the display followed by date and time of the measurement.
Note: The Up button is for reviewing the tests with the sequence number increasing, and the Down
button is for reviewing tests with sequence number decreasing. The sequence "1" is the latest result
while sequence "500" is the oldest test result.
2. To finish reviewing stored test results, press the Main button again. This will bring you to the Average
screen. By pressing the Down button, the display shows "AVG" in the upper right corner of the display
and the average value for the day. By pressing the Up or Down button you will get to the 1-day, 7-
days, 14-days, 30-days and 90-days average of your blood glucose values. You will see the number of
the calculated days in the lower left corner and the number of the calculated readings in the lower
right corner.
38
store a maximum of 500 test results with time
Down button
3. Non-Averaging set and canceled:
You may exclude unwanted or doubtful test results from the average calculation. After you finished your test in the
test mode, you can exclude the unwanted result. Keep pressing the
in the top right corner of the screen. Press the Down
value as "Non average". This value is flagged by the symbol "NO AVG" in the upper right corner of the screen.
To cancel a non-averaging setting, keep pressing the
the upper right corner of the screen. To confirm this original status, simultaneously press the Main button to confirm
the "AVG" status. The value will be stored as a regular value and included in the average values.
NOTE
- The average function requires that the correct time and date is set. If the time and date are not set correctly,
the average function will not be correct.
- The Non-averaging/re-averaging function only works in test mode and when you get a value. This action
cannot be performed in MEM mode.
Recalling Test Results and Average
Down button until you see the symbol "NO AVG"
button and the Main button simultaneously to confirm the
Down button until the "NO AVG" symbol changes to "AVG" in
39