Meter Activation And Battery Change - GE GE100 User Manual

Meter Activation and Battery change

Your GE100 Blood Glucose Meter comes with one CR2032, 3volt, battery installed. One new battery will
provide power to perform about 1000 tests under normal use. Press the main button or insert a strip to
activate your meter.
1. Turn the GE100 Blood Glucose 2. Install the battery. Be sure to put
battery in correct direction
Meter over. Press and slide
battery cover to open. (polarity (+) facing up).
4. The Meter will enter self-tesing mode automatically when replacing the battery (all symbols will show
on the screen).
5. Press any button to enter the Setting Mode.
6. You must set the time and date when replacing the battery. See Chapter "Setting Up Your Meter -
Setting the Time, Volume and Date". Test results are still stored in the memory.
CAUTION
- Please follow the local regulation and discard a used battery properly.
16
You can enter Setting Mode two ways.
1. Replace Battery
After removing the battery, press the main button several times until there is no signal on screen,
then follow the battery installation steps to replace battery. The GE100 Blood Glucose Meter performs
a self-test. Press the main button to exit the self-test and enter Setting Mode.
2. With Battery Inserted
Press the main button first to turn on the GE100 Blood Glucose Meter. Hold down the main button for
7 Seconds. During this time the screen will go blank and then after hearing a beep it will turn on into
Setting Mode. The display screen will show setting data.
3. Slide the battery cover
back until it snaps into
place.
Meter Activation and Battery change
17