Program Communications - Honeywell LYNX Touch SIA Manual

Screen Display

Program Communications

Communicator
5000-100-132-V0
Communications Path
None
APL
Disabled
City ID
CS ID
Sub ID
Supervision
24 Hours
Old Alarm Time
10 Minutes
Remote Acc. Comm.
Disabled
Multi Mode Comm.
Disabled
GSM Fault Time (min)
00
IP Fault Time (min)
00
Use DHCP
Yes
NIC IP Address
255.255.255.255
Function & Programming Options
Communicator
Program the following options:
Communications Path
City ID
Supervision
Remote Acc. Comm.
GSM Fault Time OR
IP Fault Time
Communications Path
None
IP
GSM
WiFi
WiFi & GSM
Advanced Protection Logic
Enabled
Disabled
Primary City Identification
Enter 2 digits
01-99
Primary Central Station Identification
Enter 2-digits (HEX)
01-FE
Primary Subscriber Identification
Enter 4-digits
0001-9999
Supervision
24 Hours
None
30 Days
Old Alarm Time
10 Minutes 15 Minutes
30 Minutes 1 Hour
2 Hours 4 Hours
8 Hours 12 Hours
24 Hours
Remote Access Communication
Disabled
Enabled
Note: If enabled the following option will be active.
Multi Mode Communication
Disabled
Relay Reports
Enhanced Reports
GSM Fault Time (min) (displayed if GSM is selected as Communications Path)
Enter 2-digits
00-99
IP Fault Time (min) (displayed if IP is selected as Communications Path)
Enter 2-digits
00-99
Use DHCP
Yes
No
Note: If disabled the following options will be active.
IP Fault Time
Enter 4 part address
APL
CS ID Sub ID
Old Alarm Time
Multi Mode Comm.
- 6 -