T9700HRT v1.7-2.0
Calibration Guide
STEP 1
ENTER ENGINEERING MODE
• With the SAFETY KEY in place, hold the
buttons for 5 seconds. " " N N O O N N E E " " will appear in the
"SPEED DOWN"
profile window.
• Press
until " " C C O O N N F F I I G G U U R R E E " " appears in the profile window.
"SPEED UP"
Press
.
"SELECT"
• You are now in ENGINEERING MODE.
STEP 2
SET MINIMUM SPEED
• " " P P 0 0 M M I I N N S S P P E E E E D D " " will appear in the scrolling window. " " 0 0 " " should
appear in the elevation window and " " 3 3 3 3 " " should appear in the
speed window. To adjust, Press
• Press the
or
"SPEED UP"
window reads " " 3 3 1 1 - - 3 3 5 5 " " . The running belt should be moving at .5 MPH.
• Press the
button to update the data.
"SELECT"
STEP 3
SET THE HALF MAXIMUM SPEED
• Press the
"ELEVATION UP"
" " P P 1 1 1 1 / / 2 2 M M A A X X " " . " " 0 0 " " will appear in the elevation window and " " 1 1 6 6 6 6 " " will
appear in the speed window. To adjust, press
• Press the
or
"SPEED UP"
window reads " " 1 1 6 6 3 3 - - 1 1 6 6 9 9 " " . The running belt should be moving at 6 MPH.
• Press the
button to update the data.
"SELECT"
STEP 4
SET MAXIMUM SPEED
• Press the
"ELEVATION UP"
" " P P 2 2 M M A A X X S S P P E E E E D D " " . " " 0 0 " " will appear in the elevation window and " " 3 3 2 2 0 0 " "
will appear in the speed window. To adjust, press
• Press the
or
"SPEED UP"
window reads " " 3 3 1 1 7 7 - - 3 3 2 2 0 0 " " . The running belt should be moving at 12 MPH.
• Press the
button to update the data.
"SELECT"
STEP 5
SET MINIMUM ELEVATION
• Press the
"ELEVATION UP"
" " P P 4 4 E E L L E E Z Z E E R R O O " " . " " 5 5 9 9 " " will appear in the elevation window and " " 5 5 9 9 " " will
appear in the speed window.
• Press the
or
"SPEED UP"
window reads " " 5 5 6 6 - - 6 6 2 2 " " . The treadmill should be level.
• Press the
button to update the data.
"SELECT"
Date of last revision: 12.03
"ELEVATION UP"
.
"START"
button until the elevation
"SPEED DOWN"
button until the scrolling window reads
"START"
buttons until the elevation
"SPEED DOWN"
button until the scrolling window reads
"START"
buttons until the elevation
"SPEED DOWN"
button until the scrolling window reads
buttons until the elevation
"SPEED DOWN"
and
.
.
1
TREADMILL.CALIB.REV1
Need help?
Do you have a question about the T9700HRT and is the answer not in the manual?
Questions and answers