Access To The Effects Module - Martin Exterior 400 User Manual

Access to the effects module

To access the effects module:
1. Make sure that power cannot be applied to the fixture during installation work. If the fixture has been in
use, allow it to cool for at least 30 minutes.
B
A
2. Tilt the fixture back and rest it on a piece of cloth, for example, so that it is held securely and the front
cover is facing upwards.
3. See Figure 1. Remove the eight Allen screws A that hold the front cover B, then remove the front cover
B and front cover seal C from the fixture housing F.
4. Using a T-bar or long Allen key, reach down into the housing and remove the four effects module
retaining screws D.
5. Lift the effects module up carefully. It is connected to the rest of the fixture by three multi-connectors.
Each connector has a different number of pins, so it is impossible to get them mixed up. Disconnect the
multi-connectors, then lift the effects module out of the fixture and place the module gently on a clean,
flat surface. You can now install color filters and rotating gobos.
8
D
C
Figure 1: Removing the front cover and effects module
Exterior 400 Image Projector user manual
F
E