Maintaining A Storagetek Array; Frus That Do Not Require Oracle Solaris Cluster Maintenance Procedures - Oracle Solaris Cluster 3.3 with StorageTek RAID Arrays Manual

3
C H A P T E R

Maintaining a StorageTek Array

This chapter contains the procedures about how to maintain a StorageTek array. These
procedures are specific to an Oracle Solaris Cluster environment.
This chapter contains the following procedures:
"How to Upgrade Storage Array Firmware" on page 26
■
"How to Remove a Storage Array" on page 27
■
For detailed information about storage array architecture, features, and configuration utilities,
see the StorageTek documentation listed in
FRUs That Do Not Require Oracle Solaris Cluster Maintenance
Procedures
In general, the following is a list of administrative tasks that require no cluster-specific
procedures. See the base-product documentation for these procedures. Refer to your
documentation for components not listed below.
Depending on your configuration type and the state of your cluster, a few of the following FRUs
might require cluster-specific steps. Some FRUs include the DSP and the storage array.
Adding a disk drive
■
Replacing a storage array's chassis
■
Replacing an Ethernet cable
■
Replacing a power supply
■
Replacing the power cable on the storage array
■
Replacing a power and cooling unit (PCU)
■
Replacing a controller
■
3
"Related Documentation" on page 6.
25