Drain Hose Installation - Samsung AVMWH020CA0 Installation Manual

Drain Hose Installation

Care must be taken when installing the drain hose for the indoor unit to ensure that any condensation
water is correctly drained outside. When passing the drain hose through the 65 mm hole drilled in the
wall, check that none of the following situations occur.
The hose must The end of the drain
NOT slope hose must NOT be
upwards. placed in water.
To install the drain hose, proceed as follows.
1 If necessary, connect the 2-metre extension to the drain hose.
2 If you are using the extension, insulate the inside part of the extension
drain hose with a shield.
3 Pass the drain hose under the refrigerant piping, taking care to keep the
drain hose tight.
4 Pass the drain hose through the hole in the wall, making sure that it is
sloping downwards, as shown in the illustrations above.
Do NOT bend the Keep a clearance of
hose in different direc- at least 5 cm between
tions. the end of the hose
and the ground.
5 cm
less
Ditch
Do NOT place the
end of the drain hose
in a hollow.
Shield
Drain hose
Extension drain hose
15
E-