Climatiseur numérique multifonctionnel E S F A DB98-06190A(1) OWNER’S INSTRUCTIONS MANUAL DE INSTRUCCIONES MANUEL D’UTILISATION Heat pump AVMCH052CA0 AVMCH072CA0 AVMCH105CA0 AVMCH052EA(B)0 AVMCH070EA(B)0 AVMCH105EA(B)0 System Air Conditioner Aire acondicionado sistemático Cooling only AVMCC052CA0 AVMCC072CA0 AVMCC105CA0 AVMCC052EA(B)0 AVMCC070EA(B)0 AVMCC105EA(B)0...
WARNING DANGER CAUTION If the power supply cord of this air conditioner is damaged, it must be replaced by the manufacturer or its authorized service personnel only in order to avoid a safety hazard. Do not attempt to install this air conditioner by yourself.
View of the Unit The figures are shown in this instruction may differ from yours depending on the model. Indoor Unit Timer indicator Remote control sensor Filter Sign indicator Air flow blades(outlet) Air inlet Air filter(under the grille) On/Off button On/Off indicator Fan indicator Removing frost...
Outdoor Unit TYPE A Outdoor Unit TYPE B Outdoor Unit TYPE C Outdoor Unit TYPE D Outdoor Unit TYPE E If the heat exchanger in the outdoor unit gets dusty, cooling efficiency may fall. So clean the heat exchanger with water when it becomes dirty.
Wireless Remote Controller-Buttons and Display The wireless remote controller is an optional accessory. To use the wireless remote controller, refer to an appropriate manual. Operating mode Temperature setting Fan speed Air flow direction On Timer setting Off Timer setting Battery discharge indicator - After cleaning the air filter, press the filter reset button.
Wired Remote Controller-Buttons and Display The wired remote controller is an optional accessory and it is installed on the wall. To use the wired remote controller, refer to an appropriate manual. Removing frost indicator (Except Cooling Only Models) Communication error indicator On Timer setting Off Timer setting Test indicator...
The centralized controller is an optional accessory and it is installed on the wall. To use the centralized controller, refer to an appropriate manual. Operating lamp comes on when at least one air conditioner connected to the centralized controller is operating.
HEAT mode, the outdoor unit’s fan temperatures and compressor may stop at times. This is normal ; simply wait until the air conditioner switches on again. Power failure If a power failure occurs while the air conditioner is operating, the unit will be switched off.
Temperature and Humidity Ranges The following table indicates the temperature and humidity ranges, within which the air conditioner can be used. If the air conditioner is used at... High temperature Low temperature High humidity levels Mode Outdoor Temperature Indoor Temperature Heating -20°C to 24°C approx.
Cleaning Your Air Conditioner To get the best possible use out of your air conditioner, you must clean it regularly to remove the dust that accumulates on the air filter. Before cleaning your air conditioner, ensure that you have IMPORTANT switched off the electric circuit breaker used for the unit.
Bio-Pure Filter Installation (Optional) The air conditioner can be fitted with a Bio-Pure filter to remove minute dust particles. The service life of the filter is approximately three months depending on the time during which the air conditioner is used.
They may save your time and expense of an unnecessary call. Problem The air conditioner does not Check that the breaker used for the air conditioner is switched on. operate at all Wired Remote Controller The air conditioner does not is displayed on the wired remote controller.