Fujitsu SPARC Enterprise M4000 Product Notes page 39

XCP Issues Fixed in Releases Earlier Than XCP 1091 (Continued)
TABLE 6
ID Description
RTIF1- When performing XSCF Shell commands
071129-002 remotely using SSH on the remote-control
device, the following messages might be
displayed:
stty: standard input: Invalid
argument
RTIF1- An error log cannot be registered in XSCF
071129-003 when the following message is displayed on
Solaris OS by the I/O error:
SUNW-MSG-ID: SUN4-8000-4P, TYPE:
Fault
RTIF1- The following messages are displayed and you
071129-004 might not boot Solaris OS:
• Abnormal OpenBoot environment
variable Boot process failed
• ERROR: Invalid token '' FATAL:
NVRAM contents corrupt;
Reinitializing NVRAM parameters.
RTIF1- In XSCF, write of date and time may become
071227-001 an error. When the domain powered on, the
following message may appear and the
domain may fail to be powered on.
Poweron canceled due to invalid
system date and time.
RTIF1- When the showhardconf(8) command
071227-002 executed in an environment with the External
I/O Expansion Unit, the showhardconf(8)
command may appear as if hang up.
RTIF1- When a non-existent device name specified to
071227-003 the Boot device path and resulted in the OS
Boot error, the status of I/O unit may become
"Degraded."
Workaround
None available at this time.
No workaround is available.
Confirm the OpenBoot PROM environment
variable. If the variable has errors, set the
variable again.
Execute the rebootxscf(8) command to
restart XSCF.
Press Ctrl-C to terminate the
showhardconf(8) command and execute the
showhardconf(8) command again.
Specify the correct device name to the Boot
device path.
When the status of I/O unit became
"Degraded," replace the I/O unit.
Information About Software 29