Mode-Specific Setup; Access Point Mode - Pakedge W6x User Manual

W6x User Manual

Enable/Disable: To manage the W6x remotely using an SNMP client, choose Enable.

Contact: Enter the contact information for the SNMP manager.

Location: Enter the location of the W6x for reference by the SNMP manager.

Community Name (Read only): Type the password for read-only access to the SNMP
community.

Community Name (Read/Write): Type the password for read/write access to the SNMP
community.

Trap Destination Address: Type the IP address to receive SNMP traps.

Trap Destination Community Name: Type the password of the SNMP trap community.

Click Apply to save your settings.

Mode-Specific Setup

This section describes the settings for your W6x in the four available modes:

Access Point

Client Bridge

WDS

Repeater

Access Point Mode

NOTE: The options in the main menu of the W6x change depending on the current operating mode of
the W6x. The main menu options discussed in this chapter are those available in Access Point mode.
In this mode, the W6x broadcasts a Wi-Fi signal that clients can associate with, as shown in the
figure below.
21