Table of Contents
Advertisement
Re-routing Terminal Cable
If necessary, you can have the terminal cable exit from the bottom of the camera. To do
so, remove the camera's top cover first and go ahead to detach the entire terminal cable
, along with the plastic cable gland, from the camera. Then unscrew the plastic conduit
entry cover on the bottom. Fasten the plastic cable gland to the bottom conduit entry,
and thread the terminal cable through the bottom conduit entry, and then connect the
cables to the camera's connectors. Finally, screw the plastic cover you've removed from
the camera's bottom into the side conduit entry.
Connect the Cables
Basic Cabling
The figure below shows the basic cabling of your IP camera.
1. LAN cable from PC to hub/router: If your LAN cable from PC has been connected
8
Installation
Bottom Conduit
Entry
2
3
Side Conduit
Entry
Cable Gland
Advertisement
Table of Contents
