Table of Contents
Advertisement
Chapter 2: Installation
Connecting the Cables
The picture below shows the basic connection of your IP camera.
LAN cable from PC to hub/router: If your LAN cable from PC has been connected to the Cable/ADSL
1
modem, please re-connect it to the Ethernet port of your hub/router.
Ethernet port on camera: Use the bundled RJ-45 LAN cable to connect the Ethernet port of the IP
2
camera to the Ethernet port of your hub/router.
Wireless adaptor (Optional accessory): If you have purchased the Compro USB wireless adaptor for
3
wireless connection, please plug it into the USB port of IP camera for wireless reception.
Power: Attach the power adaptor to the camera's power connector and connect the power plug to a
4
power outlet.
Figure 2-1. Connection of cables
Caution!
• The wireless connection port only supports the wireless adaptors from
Compro; please do not use other USB adaptors on Compro IP camera.
• Please do not rotate your IP camera by hand. It may cause the damage
of the IP camera.
Chapter 2: Installtion
2-1
Connecting the Cables
Advertisement
Table of Contents
