Interacoustics Affinity2.0 Quick Manuals page 9

Hearing aid fitting

Hide thumbs Also See for Affinity2.0:

Quick Guide - AC440 Protocol Setup

Introduction

This Quick Guide is intended to provide basic instructions on how to work with protocol setups in the AC440

module in the Affinity

and Callisto™ suites.

Working with Individual Setups (Test Protocols)

There are many different demands and wishes regarding how an audiometer should both function and appear

depending on the specific situation and national standards. One of the greatest advantages of the AC440

module is the flexibility, enabling you to tailor the system according to your specific preferences in the so-called

"test protocols". Below describes basic functionality on how to work with the AC440 Protocols.

Selecting a Test Protocol:

or Callisto™ Suite from Noah, OtoAccess™, or stand-alone.

1. Launch the Affinity

2. Ensure you are in the AC440 screen. Click on the AUD tab if Audiometry is not the default startup screen.

3. Under Protocols and Sessions, both factory test protocols with standard/factory test parameters and

personalized test protocols can be selected.

Note: The protocols available in the drop down will depend on whether factory defaults or country specifics

defaults were chosen during the installation of the Affinity

or Callisto™ Suite. Therefore, certain test protocols

may be hidden. To hide or un-hide protocols, go to Menu | Setup | Show/Hide Protocols.

The AC440 Main Setup:

Item No. 8105082 – 12/2013

Page 1 of 6

Callisto