Figure 5-5 Sending File Interface - Huawei Quidway S3900 Series Installation Manual

Installation Manual
Quidway S3900 Series Ethernet Switches

Figure 5-5 Sending File interface

Step 9: After completing loading, the system displays the following information:
Loading ...CCCCCCCCCC done!
Note:
You do not need to reset the HyperTerminal's baud rate and can skip the last step if you
have chosen 9600 bps. In this case, the system does not display the above prompt
message but "BootROM is updating now.....................................done!" instead.
Step 10: Reset HyperTerminal's baud rate to 9600bps with reference to Steps 5 and 6
described above. Then, press any key as prompted. The system will display the
following information when it completes the loading.
Bootrom updating.....................................done!
III. Loading host software
Follow these steps to download host software of the switch:
Step 1: Select <1> in the Boot Menu. The system displays the following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
Chapter 5 Loading Boot ROM and Host Software
Huawei Technologies Proprietary
5-10