Silicon Image Serial Ata Driver Installation - SOYO SY-P4I875P DRAGON 2 User Manual

Silicon Image Serial ATA Driver Installation

Silicon Image Serial ATA Driver Installation
You can use your Sil3112 as
1. Normal IDE function.
2. RAID function. (RAID0, 1)
To use SATA3 and SATA4 as normal IDE, please do the following steps
1. Go to the CMOS setup
Device
2. Install the Sil3112 driver, see driver installation instruction below.
To use SATA3 and SATA4 as RAID controller, please do the following
steps
1. Go to the CMOS setup
Device
2. Go to the CMOS setup
"First Boot Device" to "Other Device".
3. Set the "Other Device Boot Order" to "SATA3/SATA4,SCSI".
4. Press "Ctrl+S" or F4 when the Silicon Image BIOS summary
screen appear.
5. Create RAID set, check appendix A for more info on creating
RAID set.
To boot from the Sil3112 controller, (SATA3 or SATA4)
1. Go to the CMOS setup
First Boot Device to "Other Device".
2. Set the "Other Device Boot Order" to "SATA3/SATA4,SCSI".
For more information on the Silicon Image Utility Software, please check
the SATA RAID manual located in "d:\doc" folder in the SOYO driver CD.
Chapter 7
SOYO COMBO Feature
and set the "On-board RAID SATA3,4" to enable.
and set the "Onboard RAID SATA 3,4" to "Enable".
SOYO COMBO Feature
SOYO COMBO Feature
107
SY-P4I875P DRAGON 2
SOYO COMBO Feature
Onboard
Onboard
and set the
and set the