VIA 8237 Serial ATA Driver Installation
VIA 8237 SERIAL ATA DRIVER
You can use your VIA 8237 (SATA1, SATA2) as
1.
Normal IDE function.
2.
RAID function. (RAID 0, 1)
To use SATA1 and SATA2 as normal IDE, please do the following steps
1.
Go to the CMOS setup Integrated Peripherals VIA Onchip
IDE device "Onboard SATA1, 2" enable.
2.
Then set the SATA Mode to "IDE".
3.
Install the VIA Serial ATA driver, see driver installation
instruction below.
To use SATA1 and SATA2 as RAID controller, please do the following
steps
1.
Go to CMOS setup Integrated Peripherals VIA Onchip IDE
device "Onboard SATA1, 2"to enable..
2.
Then set the SATA Mode to "RAID"
3.
Go to the CMOS setup ADVANCED BIOS Features and set
the "First Boot Device" to "SATA1, 2, SCSI".
4.
Set the "SATA1, 2 & SCSI Boot Order" to SATA1, 2, SCSI"
Chapter 7
INSTALLATION
97
SY-KT600 DRAGON Plus