Auto Mode - Lopi Pioneer Bay Installation And Use Manual

Auto Mode

Auto mode allows you to use a thermostat to control room temperature. The heater automatically
turns on when the temperature drops below the thermostat setting. Once the heater reaches
operating temperature, the heater then runs at the heat output setting selected.
To Adjust Room Temperature (or
Start the Stove)
Move the thermostat to the heat setting
desired. If the room is cooler than the setting,
the heater will go through the start-up
sequence for approximately 10 minutes. Once
up to temperature, the heater will then run at
the heat output setting selected on the control
panel. If the room is too hot, move the
thermostat to a lesser setting.
To Adjust the Heat
Adjust the "Heat Output" dial to meet the
heating requirements you desire.
NOTE:
If you find that the heater turns on and off
repeatedly, you may wish to turn the heat
output to a lesser setting. The lower setting
will provide a more consistent heat output over
time, eliminating the need for the thermostat to
repeatedly turn the heater off.
NOTE:
If the thermostat calls for heat while the heater
is still cooling down, the heater will go through
the start-up sequence.
To Shut Down
Move the mode switch to "OFF". The exhaust
blower will still run until the heater cools down.
Travis Industries
Operation
H
E
A
T
O
U
T
P
U
T
HEAT OUTPUT
HEAT OUTPUT
4 0 2 0 2 0 4
HIGH
AUTO
MANUAL
MED
AUGER
These lights
LOW
ON
indicate the
heat output
setting.
E
AUTO
OFF
MANUAL
E
MANUAL
START
FAN
FAULT
E
AUTO
OFF
MANUAL
E
MANUAL
START
FAN
FAULT
1 7
9 3 5 0 8 0 5 1