POWER SWITCH
BALANCED SIGNAL INPUTS
The balanced signal inputs are situated on the rear panel of the unit and
are labelled as "BAL IN LEFT" and "BAL IN
RIGHT". They are fitted with gold plated XLR
sockets with metal flange from Neutrik.
Please note:
Unbalanced signals can be injected as well by
means of an adaptor. Also see page 9.
The unit is put into operation by means of the power
switch.
Power-on status is indicated by the blue LED below.
The power-on procedure takes about 5 seconds.
During this time the LED of the last selected input is
flashing and the outputs are muted.
Always the last setting is recalled.
14
Balanced XLR
Pin-out:
PIN 1
GND
PIN 2
(+) PHASE
PIN 3
(-) PHASE