Table of Contents
Advertisement
THE INSTALLATION SPACE
*Finished Width
152 mm
Electrical
2146 mm max
Area
2121 mm min
Finished
Opening
610 mm
127 mm
Water Supply
89 mm
*The finished cutout width must be 1054 mm.
Water And Electrical Locations
The opening must be prepared with the electrical
and water supply located as shown.
The cutout depth must be 610 mm
The refrigerator will project forward, slightly beyond
adjacent cabinetry, depending on your installation.
Cutout depth beneath a soffit:
When installed beneath a soffit, the soffit cannot
exceed the 610 mm installation depth shown. The
top case trim overlaps the bottom of the soffit.
Additional Specifications
• 220 volt, 50 Hz., 4.5 amps power supply is required.
An individual properly earthed branch circuit or
circuit breaker is recommended. Install a properly
earthed electrical receptacle recessed into the back
wall. Electrical outlet must be located on rear wall as
shown.
• Water line can enter the opening through the floor
or back wall. The water line should be 1/4" O.D.
copper tubing or GE SmartConnect
the cold water line and water connection location,
long enough to extend to the front of the
refrigerator. Installation of an easily accessible
shut off valve in the water line is required.
Design Guide
457 mm
127 mm
1905 mm From Floor
to Bottom
of Electrical
Area
127 mm
89 mm
™
kit between
DIMENSIONS AND CLEARANCES
1041 mm
Case Width
*2121 mm
at
Rear
1067 mm
Frame to Frame
Depth Including Handles:
683 mm Framed Models
705 mm Stainless Steel Models
Product Clearances
These refrigerators are equipped with a 2 position
door stop. The factory set 130° door swing can be
adjusted to 90° if clearance to adjacent cabinets or
walls is restricted.
130° Door Swing
330 mm
Allow minimum clearances for freezer door, 330 mm
and fresh food door, 483 mm for a full 130° door
swing and to allow for pan removal.
102 mm minimum clearance is required when door
swing is adjusted to 90°. If the 90° door stop position
is used, pan access is maintained, but pan removal is
restricted.
See illustrations pages 4 and 5 to determine door
swing interaction with adjacent cabinets or
countertops.
3
645 mm Framed Models
654 mm Stainless Steel Models
Case Depth
* Shipping height.
The refrigerator can
be adjusted to fit
into a cutout that
is 2121 min. to 2146
*2134 mm
mm max. height.
From Floor to
Note that the top
Top Frame
case trim at the
front is 13 mm
higher and will
overlap upper
cabinetry or soffit.
Use leveling legs
and wheels for a
maximum 25 mm
height adjustment.
90° Door Swing
483 mm
102 mm Min.
102 mm Min.
to Wall
606 mm
Behind
Frame
676 mm
to Wall
Advertisement
Table of Contents
