Adjusting The Iris And Master Black Of Multiple Cameras At One Time; Data Transfer Among Multiple Cameras - Sony RCP-TX7 Operating Instructions Manual

Adjustments/Settings
Gain setting a) (absolute mode)
Shutter setting (absolute mode)
• Shutter on/off
• Clear scan mode on/off
• Shutter speed
• Clear scan frequency
R/B manual white balance adjustment
(relative mode)
R/B manual black balance adjustment
(relative mode)
R/G/B manual flare correctionb)
(relative mode)
a)Do not perform command link operation in a system containing both the DXC-D30/D30P and DXC-637 series. If the
camera connected to a slave unit is different in type from the camera connected to the master unit, changing the gain value
on the master unit will set the gain value of the camera connected to the slave unit to 0 dB or the LOW position.
b)Select the manual adjustment mode also on slave units.
c)For DXC-D30/D30P only
Adjusting the Iris and Master
Black of Multiple Cameras at
One Time
For iris and master black adjustments, you can use any
one of the RCP units (whether it is the master unit or a
slave unit) specified with the IRIS/M.BLACK LINK
button.
1
Select the cameras for which you will adjust the
iris or master black by pressing the IRIS/
M.BLACK LINK buttons on the connected RCP
units. (The buttons light when pressed.)
2
Adjust the iris or master black on one RCP unit
whose IRIS/M.BLACK LINK button lights.
On the cameras connected to the RCP units whose
IRIS/M.BLACK LINK buttons light, the iris or
master black adjustments are performed by the
same amount and at the same time (on relative
mode).
To perform command link operation
Select the GAIN button on the COMM LINK ITEM-1 page in the OTHERS menu
on the master unit.
Select the SHUTTER button on the COMM LINK ITEM-1 page in the OTHERS
menu on the master unit.
b)
Select the WHITE button on the COMM LINK ITEM-2 page in the OTHERS menu
on the master unit.
b)
Select the BLACK button on the COMM LINK ITEM-2 page in the OTHERS menu
on the master unit.
b), c)
Select the FLARE button on the COMM LINK ITEM-2 page in the OTHERS menu
on the master unit.
Data Transfer Among Multiple
Cameras
The settings made on the master unit can be transferred
to the cameras connected to the slave units, if they can
be registered as a scene file (see page 21).
Perform as follows.
Press the COPY TO SLAVES button on the COPY TO
SLAVES page in the OTHERS menu on the master
unit.
Data transfer begins.
Meanwhile, on all the linked RCP units (including
units selected as neither the master unit nor slave
units), the message "COPY IN PROGRESS" is
displayed on the LCD panels and all buttons and knobs
are locked.
When the data transfer completes, the message "COPY
COMPLETED" appears on the LCD panels. The LCD
panel soon returns to the original status.
27