MEP S.p.A.
Basic instructions for carrying out a cutting cycle
Use and maintenance manual TIGER 370 CNC-- MR
5- -4
Manoeuvring the cutting head
In the TIGER 370 CNC---MR model, it is possible to move the cutting head with
up and down buttons, shown in the key of the control panel in this chapter.
Head up key Y+
Access to the cutting head
To ensure operator safety, the machine is entirely enclosed by safety guards that
prevent accidental contact with the tool and moving parts. To access the cutting
zone it is necessary to unlock the device closing the door.
Button to open/close the door of the cutting head
Manoeuvring the feeder
The power supplier can be moved with the buttons reported on the diagram
below, only after having reset the power supply (as explained in the "machine
start up" paragraph).
Forward key X+
Clamping the work piece in the vice
Vice opening and closure, for the cutting vice and the feeder vice, are controlled
by the corresponding buttons on the control console.
Cutting Vice close button
Feeder vice close button
Head down key Y- -
Back key X- -
Cutting vice open button
Feeder vice open button
29