Feed Side Roller Table Support; Motor Chip Discharger Unit - Tiger 370 CNC--MR Use And Maintenance Manual

MEP S.p.A.
Use and maintenance manual TIGER 370 CNC-- MR
11- -4

Feed side roller table support

This device is used to increase the load---bearing strength of the roller table, both
during feeding and discharge. The steps which should be followed to assemble it
are illustrated below.
" Disconnect the table from the adapter (on the discharge side, for example);
" position the support to correspond with the holes on the base of the trailer
and reconnect to the adapter.

Motor chip discharger unit

This device can be used to eliminate the chips from the chip collection drawer; for
installation, proceed as follows:
" disconnect the machine from the power supply;
" extract and remove the chip collection drawer;
" fit the lower part of the discharger unit in the place of the drawer, making the
holes coincide for the screws;
" adjust the discharger unit feet so that the conveyor belt is slightly tilted;
" connect the machine to the power supply again;
" start the machine and select the operating mode on the control panel; from
left to right in order: manual, inactive, automatic.
168