Adjusting The Anti- -Chip Device - Tiger 370 CNC--MR Use And Maintenance Manual

MEP S.p.A.
Use and maintenance manual TIGER 370 CNC-- MR
7- -18

Adjusting the anti- -chip device

The vice is fitted as standard with a rag prevention device that serves to support
the material and prevent the formation of ragged edges at the end of the cut. To
adjust the rag prevention device transversely:
" loosen the release lever (1) located above the vice slide;
" movement the rag prevention device arm to the right or left;
" tighten the release lever.
To adjust the longitudinal position of the vice jaw, proceed as follows:
" tighten the cutting vice completely;
" slacken the two screws located to the side of the rag prevention device (2---3);
" slacken the nut that locks the grub screw;
" adjust the longitudinal position of the rag prevention vice jaw by slackening or
tightening the grub screw (4) until the position of the rag prevention jaw is
aligned with that of the cutting jaw;
" hold the bolt still using the hexagonal key and tighten the blocking nut.
1
4
2
3
140