MEP S.p.A.
Mechanical systems
Use and maintenance manual TIGER 370 CNC-- MR
7- -12
Cutting head stroke
The head cutting stroke is defined by the cut start position (Head Upstroke
Limit) and cut end position (Head Downstroke Limit) which are electronically
programmed by the control console. The cutting head is also equipped with a
mechanical stop which defines the bottom limit of its stroke:
" to adjust this stop, use two hex wrenches, one to lock the nut and the other to
tighten or slacken the stop screw.
Adjusting the position of the blade- - cleaning brush
When the cutter disk is not clean enough, check the blade---cleaning brush for
wear and if it's working correctly. The figure below illustrates how the brush
should be adjusted if need be.
" Loosen the screw highlighted in the drawing, and remove the protection;
134