Rear Oil Seal Case Installation; Flywheel Bolt / Drive Plate Bolt Installation - Mitsubishi 4G1 Series General Information Manual

11A-12-8
4G1 ENGINE (E - W) -
MD998781
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
"EA REAR OIL SEAL CASE INSTALLATION
(1) Apply liquid gasket to the rear oil seal case at the illustrated
(2) Apply a suitable amount of engine to the entire periphery
"FA FLYWHEEL BOLT / DRIVE PLATE BOLT
(1) Clean off sealant, oil and deposits from the threaded
(2) Apply engine oil to the bolt flange and to the threaded
(3) Apply sealant to the threaded portion of the bolt (if the
(4) Using the special tool, secure the drive plate and tighten
Nov. 1995
Aug. 2000
Crankshaft and Cylinder Block
position if it has no pre-formed gasket attached.
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent
Caution
Squeeze the liruid gasket uniformly so that there is
no break in the gasket nor is there too much gasket.
of the oil seal lip and install the oil seal on the cylinder
block.
INSTALLATION
portion of the drive plate/adapter plate tightening bolts
and from the threaded holes on the crankshaft.
holes on the crankshaft.
bolt is reused).
Specified sealant:
3M Nut Locking Part No. 4171 or equivalent
the bolts to the specified torque.
PWEE9520
PWEE9520-D Added