Removal Service Points; Timing Belt / Tensioner Spring / Timing Belt Tensioner Removal; Camshaft Sprocket Bolt Removal; Timing Belt Removal - Mitsubishi 4G1 Series General Information Manual

MD998715
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
4G1 ENGINE (E - W) -

REMOVAL SERVICE POINTS

AA" TIMING BELT / TENSIONER SPRING / TIMING
(1) Using pliers, grip the tensioner spring projection (marked
(2) Remove the timing belt tensioner.
(3) If the timing belt is to be reused, chalk an arrow on the
AB" CAMSHAFT SPROCKET BOLT REMOVAL
(1) Using the special tools shown in the illustration, lock the
MB990767
(2) Loosen the camshaft sprocket bolt.
AC" TIMING BELT REMOVAL
(1) If the timing belt is to be refused, it is necessary to install
(2) Using pliers and the like, hold the tensioner spring at
(3) Loosen the timing belt tensioner securing bolt.
(4) Move the timing belt tensioner in the direction shown
Securing bolt
Nov. 1995
Aug. 2000
Timing Belt
BELT TENSIONER REMOVAL
"A" in the diagram)and remove it from the oil pump case
stopper. Then, remove the tensioner spring.
belt to indicate the direction of rotation before removing
it. This will ensure the timing belt is fitted correctly when
reused.
camshaft sprocket in position.
it in the same direction as it was before. Mark an arrow
that shows the direction of rotation on the back surface
of the timing belt with chalk, etc.
the illustrated position, and remove the spring.
Caution
Do not cause the end of the tensioner spring to give
damage to the timing belt.
to remove the timing belt.
PWEE9520
PWEE9520-D
11A-4-3
Revised