Amana AAC051STA Owner's Manual page 7

V. Entretien courant
MISE EN GARDE
Pour réduire le risque d’électrocution, de
blessures ou de décès, tourner la
commande de ventilation à «off» (fermé) et
débrancher l’appareil avant de procéder à
toute inspection ou travail d’entretien.
INSPECTION ANNUELLE
Remarque :
PanGuard MD
CDC Anti-Clog
MD
RETRAIT DU FILTRE ET DE LA GRILLE AVANT
Saisir la poignée du filtre et faire glisser le filtre hors de
l’appareil.
DEUXIÈME MÉTHODE :
1. Pousser la grille avant sur les coins inférieur et
supérieur droits.
2. Ouvrir la grille pour exposer le filtre.
3. Incliner le filtre et le retirer.
FILTRE ÉLECTROSTATIQUE
NETTOYAGE DU BOÎTIER ET DE LA GRILLE AVANT
NETTOYAGE DU FILTRE À AIR
Ne pas faire
fonctionner l’appareil sans le filtre.
MOTEUR DU VENTILATEUR
54
Important Safety
Grounding Instructions
Information
For safety, air conditioner must be grounded. All air conditioner power supply
cords are equipped with 3-prong grounding plug. Plug on cord must be plugged
About Ground Wires
into appropriate outlet that is properly installed and grounded in accordance with
all local codes and ordinances. Do not modify plug on air conditioner cord. If
In the event of an electrical short circuit, a
plug will not fit outlet, have qualified electrician install proper outlet.
ground wire reduces the risk of electric
shock by providing an escape wire for the
About Personal Protection
electric current.
Always wear safety glasses and snug fitting work gloves when handling air
Standard accepted color coding for ground
conditioner, or its parts.
wires is green or green with a yellow stripe.
Grounding wires and wires colored like
grounding wires are NOT to be used as
To avoid risk of personal injury or death due to electrical shock:
current carrying conductors.
• Observe all local codes and
ordinances.
• Disconnect electrical power to
unit before servicing.
• Ground appliance properly.
• Check with a qualified
electrician if you are not sure
this appliance is properly
grounded.
• DO NOT ground to gas line.
• DO NOT ground to cold water
pipe if pipe is interrupted by
plastic, nonmetallic gaskets,
Model AAC051STA
or other insulating
AAC061STA (nonconducting) materials.
1
REMOVE SHIPPING
SCREWS, APPLY
WINDOW SILL & SASH
GASKET
Remove 4 shipping screws shown in illustration.
Raise indoor sash. Measure width of window
sash. Cut window sash gasket to length and
apply to bottom of window sash. Cut window sill
gasket and apply.
2
ASSEMBLE
CURTAINS
Unpack unit on floor next to
installation location.
Slide left-hand curtain assembly into
left ends of top and bottom rails.
Repeat for right-hand curtain assembly.
Fasten curtain retainer strips to sides
of outer case with six 10-mm screws.
Caution: Never expose plastic front
or grille to extreme
temperatures.
WARNING
• DO NOT modify plug on power
cord. If plug does not fit
electrical outlet, have proper
outlet installed by qualified
electrician.
• DO NOT have a fuse in the
neutral or ground circuit. A fuse
in the neutral or ground circuit
could result in an electrical
shock.
• DO NOT use an extension cord
with this appliance.
• DO NOT use an adapter plug
with this appliance.
• DO NOT pinch power cord.
7