Amana AAC051STA Owner's Manual page 10

2
ASSEMBLE
CURTAINS/TOP
RAIL
Remove paper backing from top rail
gasket and adhere to bottom of top rail.
Install top rail with three or four 10-mm
screws depending on unit style. Slide
left-hand curtain assembly into left end of
top and bottom rails. Repeat for right-
hand curtain assembly. Fasten curtain
retainer strips to sides of outer case with
six or eight 10-mm screws depending on
unit style.
3
PREPARE
Storm window installation
If storm window frame does not allow
WINDOW FOR
adequate clearance below sill (1/2”
INSTALLATION
required), remove storm window
frame or create clearance by adding a
Inspect window track, sash, and sill
wood strip (at least 1 1/2” wide) along
for its ability to support the weight of
entire width of sill. Fasten wood strip
air conditioner.
to sill with at least three countersunk
Measure width between window
wood screws (not supplied with kit).
moldings to ensure Instant Mount
This provides a smooth surface for
window mounting kit will fit window
mounting air conditioner.
frame. Instant Mount models are
designed for windows from 24” to
35” wide (AAC05,AAC07), 25” to 35”
1 1/2"
Minimum
(AAC08), 26” to 36” (AAC10,
AAC12), 30” to 40” (AAC14), 32” to
Wood
44” (AAC18, AAC20).
Strip
SILL
Instant Mount kit supplied with unit
is designed for mounting in most
I
double-hung windows without
N
D
storm windows. For installation in
O
window frame with storm window,
O
R
modify sill by adding wood strips to
inner and outer sills. This raises unit
Storm Window
and eliminates interference of storm
Frame
window frame.
4
APPLY WINDOW
SASH GASKET
Raise window sash. Measure width
of window sash, including portion
inside window track. Cut window
sash gasket to length and apply to
bottom of window sash. Cut and
apply window sill gasket.
Mobile home window installation
Add wood strip (at least 1 1/2” wide)
along entire width of window sill.
Thickness of wood strip should match
height of front lip on window frame.
Fasten wood strip to sill with a
minimum of three countersunk wood
screws (not supplied with kit). This
provides a smooth surface for
mounting air conditioner.
Must be a minimum
1/2"
of 1/2" to clear
Minimum
bottom rail on unit
1 1/2"
Minimum
Wood
Strip
I
O N
U
D
T
O
D
O
O
R
O
R
10
5
INSTALLER LE BOÎTIER EXTÉRIEUR
DANS LA FENÊTRE
REBORD
REMARQUE :
Window
Frame
6
O
POSER LE COUDE DE
U
BASE ET LE JOINT
T
D
D’ÉTANCHÉITÉ DE LA
O
FENÊTRE
O
R
Niveau
Guillotine de
la fenêtre
Le rideau a été
éliminé du diagramme
à des fins de clarté.
ATTENTION :
51
Vis de
25 mm
Coude de
base