How Can I Troubleshoot My Display - Raymarine C-Series Installation Manual

Chapter 4: Maintenance & Troubleshooting
What is a factory reset?
CAUTION: Factory Reset
The factory reset will set all values back to their original factory settings.
This reset also clears the Waypoint and Route List databases.
How do I carry out a factory reset?
To carry out a factory reset:
1. Press and hold the left hand soft key.
2. Press POWER to power-up the display.
The factory reset will take place during this operation.
What is a Power-on reset?
A power-on reset causes the screen to revert to the chart or radar picture with all the
windows cleared.
How do I carry out a power-on reset?
You can carry out a power-on reset by turning the display off and on again.
What is a picture reset?
A picture reset returns the screen to a full screen display of the top window with all
other windows cleared.
How do I carry out a picture reset?
You can carry out a picture reset by pressing and holding the PAGE button for two
seconds.

4.4 How can I troubleshoot my Display?

All Raymarine products are, prior to packing and shipping, subjected to
comprehensive test and quality assurance programs. However, if your C-Series Display
unit should develop a fault, this section will help you to identify the most likely cause
and show the corrective action required to restore normal operation.
If, after referring to this section, you are still having problems with your Display, contact
your local dealer, national distributor or Raymarine Technical Services Department for
further advice.
Always quote the product serial numbers which are printed on the back of the unit.
offered by Busse-Yachtshop.com
-53