Table of Contents
Advertisement
Chapter 5
Packet-classified forwarding
The PPP interface and semi-dynamic route
Proceed as follows to configure the PPP interface and to add a semi-dynamic route.
1
Browse to Connections > Routed PPPoA.
2
Add a new PPP interface.
3
Create a route that will be added to the routing table when the PPP link comes up and will be removed
when the link goes down.
i
Destination 0/0 means to all users or all networks.
The route addition will only works when then PPP link is up and when the peer address has
been assigned.
4
Click on Connect to attach the PPP interface.
5
Click Save All to save the configuration.
E-DOC-CTC-20051017-0168 v1.0
41
Advertisement
Table of Contents
