Table of Contents
Advertisement
3 6
WARNING - DO NOT REMOVE OR COVER THIS LABEL
Listed Pelletized Solid Fuel Burning Appliance
For use in masonry or factory built (ZC) fireplaces.
Serial No.
Model: Yankee Bay PI
(Heritage Bay PI)
Report No.: 028-S-51-2
Tested to: ASTM E1509-95
Maximum Input Rating: 5.5 lbs (2.50 kg)/hr
This pellet appliance has been tested and listed for use in manufactured homes
in accordance with Oregon Administrative Rules 814-23-900 through 814-23-909.
Install and use only in accordance with the installation and operating
instructions. Contact local building or fire officials about restrictions and
installation inspection in your area. Do not remove bricks or mortar from
masonry fireplace or alter factory built fireplace.
Combustible floor beyond hearth extension must be protected by a non-combustible material, extending 6 in/150 mm (E) to the front and 6 in/150 mm (F) to the sides of door
opening. Do Not Connect This Unit to a Chimney Flue Serving Another Appliance. Components Required for Masonry Fireplace and Factory Built Fireplace Installation: Listed
4 in diameter flue liner.
For use with 1/4 in/6 mm to 5/16 in/7 mm diameter pelletized wood fuels that comply with premium grade standards set by Association of Pellet Fuel Industries. Replace glass
only with 5 mm ceramic glass available from your dealer.
DANGER: Risk of electric shock. Disconnect power before servicing unit. Do not route power cord beneath heater. The space beneath the heater must not be obstructed. Do
not obstruct combustion air openings. Operate only with viewing door closed and with ashbox and ashpan in place. Keep all furnishings well away from heater. Do Not Overfire
– If Heater or Chimney Connector Glows, You Are Overfiring. Inspect And Clean Chimney Frequently – Under Certain Conditions of Use, Creosote Buildup May Occur Rapidly.
CAUTION
BURNS. SEE THE NAMEPLATE AND INSTRUCTIONS. OPERATE THIS UNIT ONLY WITH THE
FUEL HOPPER LID CLOSED. FAILURE TO DO SO MAY RESULT IN EMISSION OF PRODUCTS
OF COMBUSTION FROM THE HOPPER UNDER CERTAIN CONDITIONS. MAINTAIN HOPPER
SEAL IN GOOD CONDITION. DO NOT OVERFILL HOPPER.
© Travis Industries
Safety Label
Travis Industries, Inc.
10850 117th Pl. NE
Kirkland, WA 98033
Electrical Rating: 115 V., 60 Hz.,
Start 3 Amps,
Run 1.5 Amps
HOT WHILE IN OPERATION. DO NOT TOUCH. KEEP CHILDREN,
CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE SKIN
4 0 8 0 7 2 3
INSERT CLEARANCE DIAGRAM
MANTEL
B
C
A
Pellet
Insert
F
E
HEARTH
EXTENSION
Minimum Clearance to Combustible Materials
(Measured from insert top)
Adjacent Sidewall
A
Mantel
B
Top Facing
C
Side Facing
D
DATE OF MANUFACTURE
2003
Jan.
2004
Feb.
2005
Mar.
2006
Apr.
D
8.75 in
11.5 in
6.25 in
7 in
May
Sep.
Jun.
Oct.
Jul.
Nov.
Aug.
Dec.
0467
(IGN)
1 0 0 - 0 1 1 4 5
Advertisement
Table of Contents
