Connecting Gerber Edge Fx - Gerber EDGE FX Installation Manual

Connecting GERBER EDGE FX

See the following illustration of the GERBER EDGE FX back panel.
Fuse carrier
plate
Power switch
Power cord
receptacle
After connecting the computer to the GERBER EDGE FX, plug the power cord into the
receptacle at the back of the printer and then into a 110 V power outlet. Turn on the power
switch located at the back of the printer. During the power up cycle the GERBER EDGE
displays:
Before printing the GERBER EDGE FX warms the Thermal Print Head (TPH) and displays a
message on the bottom line of the display. When the TPH reaches operating
Warming ********
temperature the display changes to:
GERBER EDGE FX back panel
F1 Gerber EDGE FX
F2 Release: X.X.XX
MAIN MENU
F1 OFFLINE
F2 Mode: Single
F3
F4
CANCEL F3
SYSTEM F4
9
Future use
RJ45 Jack