Manual Draining Of The Water Heater - Rinnai V75i Installation And Operation Manual

Direct vent tankless water heater
Hide thumbs Also See for V75i:
Table of Contents

Advertisement

Available languages

Available languages

 
Manual Draining of the Water Heater 
WARNING
If the water heater is not going to be used during a period of possible freezing weather, it is recommended that 
the water inside the water heater be drained.   
To manually drain the water: 
1.  Shut off cold water supply and gas supply. 
2.  Turn off the temperature controller. 
3.  Disconnect the power to the water heater. 
4.  Place a container to catch the water. Remove the drain caps on 
both isola on valves and open both valves above the caps (blue 
and red valve handles).  ‐OR‐  Open the pressure relief valve. 
5.  Remove water filter to drain the cold water. 
To resume normal opera on: 
1.  Confirm that the gas supply is turned off, and that all taps are 
closed. 
2.  Screw in the water filter in the cold water inlet. 
3.  Replace the drain caps and close both isola on valves. ‐OR‐  Close 
the pressure relief valve. 
4.  Open the cold water supply. 
5.  Open a tap and confirm that water flows, and then close. 
6.  Turn on the power. 
7.  A er confirming that the temperature controller is off, turn on the 
gas supply. 
8.  Turn on the temperature controller. 
Running a low volume of water through the water heater to prevent freezing 
If the temperature exceeds the ability of the water heater to freeze protect itself, 
or if power is lost, the following steps may prevent the water heater and external 
piping from freezing.  (Units connected with  EZ Connect (2 unit link) should be 
drained to prevent freezing if not in use.) 
1.  Turn the water heater off. 
2.  Close the gas supply valve. 
3.  Turn on a hot water tap to flow water about 0.1 gal/min or where the stream 
is about 0.2 inches thick. 
When the water heater or external piping has frozen 
1.  Do not operate the water heater if it or the external piping is frozen. 
2.  Close the gas and water valves and turn off the power. 
3.  Wait un l the water thaws.  Check by opening the water supply valve. 
4.  Check the water heater and the piping for leaks. 
 
To avoid burns, wait un l the equipment cools down before draining the water.  The 
water in the appliance will remain hot a er it is turned off. 
Value Series Manual 
Hot water 
outlet 
ON!
COLD
HOT
0.1 gal/min or 
about 0.2 inch 
thick 
Water 
filter 
Cold water 
inlet 
39 

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents