Checklist To Determine Installa On Loca On; Mount To Wall; Remove The Front Panel - Rinnai V75i Installation And Operation Manual

Direct vent tankless water heater
Hide thumbs Also See for V75i:
Table of Contents

Advertisement

Available languages

Available languages

 
Checklist  to Determine Installa on 
Loca on 
□ 
The water heater is not exposed to corrosive 
compounds in the air. 
□ 
The water heater loca on complies with the 
clearances. 
□ 
For indoor models, the planned ven ng will not 
exceed the maximum length for the number of 
elbows used.   
□ 
The planned ven ng termina on/air intake 
loca on meets the clearances. 
□ 
The water supply does not contain chemicals or 
exceed total hardness that will damage the heat 
exchanger. 
  A standard 3 prong 120 VAC, 60 Hz properly 
grounded wall outlet (for indoor models) or other 
120 VAC, 60 Hz source is available. 
□ 
The installa on must conform with local codes or, 
in the absence of local codes, with the Na onal
Fuel Gas Code, ANSI Z223.1/NFPA 54, or the 
Natural Gas and Propane Installa on Code, CSA
B149.1.  If installed in a manufactured home, the 
installa on must conform with the Manufactured
Home Construc on and Safety Standard, Title 24
CFR, Part 3280 and/or CAN/SCA Z240 MH Series,
Mobile Homes. 
□ 
Leave the en re manual taped to the water 
heater (indoor models), temperature controller 
(outdoor models), or give the en re manual 
directly to the consumer. 
12 
Mount to Wall 
1.  Iden fy the installa on loca on and confirm that 
the installa on will meet all required clearances. 
2.  Securely a ach the water heater to the wall 
using any of the holes in the wall installa on 
brackets which are at the top and bo om of the 
water heater.  Ensure that the a achment 
strength is sufficient to support the weight.   
Refer to the weight of the water heater in the 
Specifica ons sec on. 
Use a leveling tool to ensure that the water 
heater is level.  Proper opera on requires that 
the water heater be level. 
NOTE: The water heater should be installed in an 
upright posi on.  Do not install upside down or on its 
side. 
Remove the Front Panel 
Slide the plas c trim pieces on each side of the water 
heater to expose the screws. 
Remove the 4 screws and pull off the front panel. 
 
Value Series Manual 
wall installa on 
brackets 

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents