Troubleshooting - Jet JOVS-10 Owner's Manual

Trouble
Sander will not start
Sanding drum does not come
up to speed
Machine vibrates excessively
Sanded edge not square
Sanding marks on wood

Troubleshooting

Possible Cause
1. Sander unplugged from wall
or motor
2. Fuse blown or circuit breaker
tripped
3. Cord damaged
4. Starting capacitor bad
1. Extension cord too light or
too long
2. Low current
1. Stand or base on uneven
surface
1. Table not square to sanding
drum
1. Wrong grit sanding sleeve
2. Feed pressure too great
11
Solution
1. Check all plug connections
2. Replace fuse or reset circuit
breaker
3. Replace cord
4. Replace starting capacitor
1. Replace with adequate size
and length cord
2. Contact a qualified electrician
1. Adjust stand or base so that
it rests evenly on the floor
1. Use a square to adjust table
to sanding drum
1. Use coarser grit for stock
removal and fine grit for
finish sanding.
2. Never force workpiece