Lubrication - Jet JWP-16OS Owner's Manual

Lubrication

The bearings on the cutterhead are factory
lubricated and sealed for life – no lubrication
required.
Gearbox – The oil in the gearbox must be
drained and replaced after the first 20 hours of
operation. (See the Lubrication Table).
Inspect levels periodically and change yearly.
Replace gear oil more frequently under heavy
use. Fill until the oil reaches the top of the filler
plug port for correct oil level.
Figure 39
No Fig Position
1 39 Drive Chain
2 39 Gear Box
3 41 Lead Screw
4 41 Column
5 42 Table Chain
6 43 Feed Rollers
Interval
Inspect and lubricate monthly
When operated more
2,500 hours
Inspect and lubricate Monthly
Inspect and lubricate weekly
Inspect monthly – lubricate
when needed
Inspect and lubricate
before startup
Lubrication Table
23
To replace the gearbox lubricant:
1. Remove the drain plug (3. Fig. 39), and filler
cap (A, Fig. 40). Drain dirty oil thoroughly.
2. Tighten the drain plug (3, Fig. 39).
3. Fill with clean
(A, Fig. 40).
Tighten filler cap (A, Fig. 40).
Figure 40
Suitable Types of Lubricant
Grease
than HD-100, Mobil Gear 627, Shell Omala
100, ESSO Spartan EP-100
Grease
SAE-30
Grease or good quality bicycle chain
lubricant
daily
SAE-30
lubricant through hole