Moving Off; Changing Gears - Triumph Tiger 800 User Manual

How to Ride the Motorcycle

Moving Off

Pull in the clutch lever and select first gear.
Open the throttle a little and let out the clutch
lever slowly. As the clutch starts to engage,
open the throttle a little more, allowing
enough engine speed to avoid stalling.

Changing Gears

1
cgiu
1. Gear-change pedal
Close the throttle while pulling in the
6
clutch lever. Change into the next
5
4
higher or lower gear. Open the throttle
3
part way, while releasing the clutch
2
N
lever. Always use the clutch when
1
changing gear.
56
Warning
Take care to avoid opening the throttle too
far or too fast in any of the lower gears as
this can lead to the front wheel lifting from
the ground (pulling a 'wheelie') and to the
rear tyre breaking traction (wheel spin).
Always open the throttle
particularly if you are unfamiliar with the
motorcycle, as a 'wheelie' or loss of traction
will cause loss of motorcycle control and an
accident.
Note:
• The gear change mechanism is the
'positive stop' type. This means
that, for each movement of the
gear change pedal, you can only
select each gear, one after the
other, in ascending or descending
order.
Warning
Do not change to a lower gear at speeds
that will cause excessive engine rpm
(r/min). This can lock the rear wheel
causing loss of control and an accident.
Engine damage may also be caused.
Changing down should be done such that
low engine speeds will be ensured.
cautiously,