Triumph Tiger 800 User Manual page 41

To adjust the handlebars, loosen and remove
the handlebar rear (8 mm threaded) clamp
bolts, and then the front (10 mm threaded)
clamp and riser bolts.
1
2
cgil
1. 10 mm fixings
2. 8 mm fixings
Lift the handlebars out of the handlebar risers
and support with the aid of an assistant.
Rotate both risers through 180° and align the
bolt holes.
Reposition the handlebars to the risers.
Refit the upper clamps, and secure with the
two 10 mm threaded bolts in the rear bolt
positions. Do not fully tighten the bolts at this
stage.
General Information
Rotate the handlebar so that the etched
centre (longer) marking on the handlebar
aligns with the split line on the upper clamps/
risers.
ceic
1. Upper clamp
2. Clamp split line
3. Centre marking
Tighten the 10 mm bolts to 35 Nm.
Refit the 8 mm bolts to the front positions
and tighten to 26 Nm.
1
2
3
41