Motorola IMPRES Installation Manual page 20

Charger Calibrating an IMPRES Battery
LED
Line 1
Line 2
LED
Line 1
Line 2
* All IMPRES batteries should be calibrated before ini-
tial use. Charger will automatically initiate calibration
for all new batteries.
Battery Capacity Data is Displayed as % in
mAH, and Voltage
LED
Line 1
Line 2
Note: Not shown for uncalibrated batteries.
Note: Display will show slightly lower capacity after
reaching charge completion if battery inserted in
another pocket due to stand loss calculations, but the
charger will correct this deviation when the battery
reaches full charge in the new pocket, typically in a
few minutes.
Steady YELLOW, RED,
Flashing YELLOW or GREEN
Calibrating
Battery
Steady GREEN
Battery
Calibrated
Defined by Charge State
----% RATED CAP.
----mAH --.-V
18