Polycom SoundStation IP 7000 Setup Manual page 20

Setup Guide for the Polycom SoundStation IP 7000 Phone
Note
Note
1 - 14
When you connect your phone to a Polycom HDX system or Polycom
RealPresence Group system, you do not need to connect your phone to a
power source (even if you want to attach Polycom Microphone Arrays to your
phone). The Polycom HDX system or Polycom RealPresence Group system
provides the power source.
To connect your phone to a Polycom HDX system or Polycom RealPresence Group
system:
You can only connect a single-phone setup to the Polycom HDX system or Polycom
RealPresence Group system. That is, you cannot connect two phones together
(using the Console Interconnect Cable), and then connect the phones to a
Polycom HDX system or Polycom RealPresence Group system.
1. (Optional, but highly recommended.) Connect your phone to the
network:
If you want to use a Multi-Interface Module (to access auxiliary audio connectors),
follow the steps for Connecting Your Phone Using AC Power (One Phone, with
Multi-Interface Module)
Connect the 7.6m (25ft) Network Cable to the LAN jack on your
a
phone.
Connect the other end of the 7.6m (25ft) Network Cable to an available
b
LAN port on the wall or hub/switch device port.
The following figure shows how to connect your phone to the
network.
on page 1-5, and then go to step 2.
7.6m (25ft)