Quick Dial; Create A Quick Dial Number; Dial A Quick Dial Number; Answering Machine - Geemarc CL210A Instructions Manual

QUICK DIAL

This telephone has 3 quick dial memory buttons.
Once a number has been stored in a memory location, you only need to
press one button to make the call.

Create a Quick Dial Number

Lift the handset
Press
Enter the telephone number to be stored (maximum of 16 digits)
Press
Select the quick dial location to store the telephone number (M1, M2
or M3) by pressing the corresponding button
Replace the handset
NOTE: Press if you need to insert a pause in the telephone number

Dial a Quick Dial Number

Lift the handset and wait for a dial tone
Press the quick dial location required (M1, M2 or M3)
The stored telephone number will now be dialed
again
15

ANSWERING MACHINE

Switching the Answering Machine On/Off

The answering machine can be switched on and off by using the
button. When switched to ON position, incoming calls will be answered by
the answering machine after a certain number of rings (see Answering
Machine Settings). When the answering machine answers an incoming
call, the caller will hear your outgoing message. After a short beep they
can then leave a message of up to 2 minutes. Should the caller exceed
this limit, the call will be disconnected. If the caller stops speaking for
longer than 7 seconds during the 2 minutes, the answering machine will
disconnect.
The memory will store approximately 14 minutes of incoming messages
(including the outgoing message).
NOTE: IF THE ANSWERING MACHINE IS OFF, NO CALLS WILL BE
ANSWERED AND 2 BARS WILL BE DISPLAYED
Also, if the Answering Machine is OFF, it will answer a call after 10 rings.
This is to allow some features to be accessed remotely.
Your CL210A answering machine can be operated from either:
•
the telephone unit
•
remotely from any external telephone.
Outgoing Message
Before you use the answering machine you should record an outgoing
message. The outgoing message is your message to an incoming caller
and may be up to 60 seconds in length.
You may want the message to tell the caller that they may start speaking
once the beep is heard.
NOTE: If no outgoing message has been recorded the display will flash
and no messages can be left.
16