Listening To Messages; Delete An Incoming Message; Call Screening; Operating The Answering Machine Remotely - Geemarc CL210A Instructions Manual

ANSWERING MACHINE

Listening to Messages

The display flashes to show how many new messages have been
received. If no new messages have been received the display shows total
messages (old).
Playback will always begin with any new messages. For example if there
are three old messages and two new ones, only the two new ones will be
played back, then the answering machine will return to standby mode.
Press the play button once again to listen to all messages, starting with the
oldest messages.
Press to start playback.
/
If you want to pause during playback of a message press
message will pause (max. 7 seconds).
Press again to resume playback.
When playback is finished you will hear two short beeps, and the machine
will return to standby mode. All incoming messages are saved (unless you
have erased any during playback, see below), new messages will then be
recorded after the old ones.
Other Functions available during Playback
Skip to next message
Repeats the current message, or hold down until you hear
a beep to step back through the messages
ON/OFF Stop playback
C Erase messages
Playback through handset receiver (+40dB volume)
To playback your messages through the handset, pick-up the handset and
press . You can now you can press
volume to 40dB
and the
to boost the message
19
ANSWERING MACHINE
Delete Incoming Messages
If you want to delete a single incoming message press
message is playing.
To erase all messages after playback, press and hold
heard.
Please note that new messages cannot be deleted until they have been
played.

Call Screening

Incoming messages can be heard through the Speakerphone as they are
received. If there is no sound adjust the volume using the control on the
right hand side of the telephone.
If you want to speak to the caller, lift the handset. If the recording does not
stop automatically, press on the answering machine, or press * (for 2
seconds) on the telephone.

Operating the Answering Machine Remotely

This answering machine can be accessed remotely using the keys of an
ordinary tone dialing telephone. Call the answering machine (using your
telephone number) and enter the remote code while the outgoing message
is playing. Once the code is accepted, several remote control commands
are available.

Remote Code

A confidential three digit code is required to activate/deactivate the
answering machine or listen to your messages from a remote external
telephone. The remote code is printed on the base of the machine.
C
while the
C
until a beep is
20