Care And Cleaning - AGA marvel 30ARM Installation, Operation And Maintenance Instructions

Condenser Air Flow
Disconnect the power cord before cleaning the condenser.
The condenser underneath the cabinet does not require fre-
quent cleaning; however, satisfactory cooling depends on ad-
equate ventilation over this heat exchanger. It is recommended
to annually clean the condenser by vacuuming and brushing.
For 15" wide models (30ARM,3OARM)
To access the condenser, the unit must be pulled out from the
installation, and the lower machine compartment access cover
removed.
For 24" wide models (61ARM,6OARM,6ADAM)
Access the condenser, from the front of the unit by removing
the toe grille. (See Figure 14). Remove the 2 screws holding the
toe grille in place with a phillips screwdriver. The condenser
is located 2-1/2" (6.4cm) behind the toe grille on the left side
of the cabinet. We recommend using a refrigerator coil clean-
ing brush to loosen the dust and dirt, then vacuuming.
Be sure that nothing obstructs the required air flow openings
in front of the cabinet. At least once or twice a year, brush or
vacuum lint and dirt from the front grille area (see page 4).
Cabinet
The painted cabinet can be washed with either a mild soap and
water and thoroughly rinsed with clear water. NEVER use abra-
sive scouring cleaners.
Interior
Wash interior compartment with mild soap and water. Do NOT
use an abrasive cleaner, solvent, polish cleaner or undiluted
detergent.
Care of Unit
1. Avoid leaning on the door, you may bend the door hinges or
tip the unit.
2. Exercise caution when sweeping, vacuuming or mopping
near the front of the unit. Damage to the grille can occur.
3. Periodically clean the interior of the unit as needed.
4. Periodically check and/or clean the front grille as needed.

CARE AND CLEANING

Light Bulb Replacement
DISCONNECT THE POWER CORD BEFORE ATTEMPTING LIGHT
BULB REPLACEMENT. Failure to do so may result in an electrical
shock that could severely injure you.
The refrigerators use one, 25 watt incandescent light bulb to
illuminate the interior. The light bulb is a very reliable electrical
component, but should it not function properly, please call the
dealer where you purchased your refrigerator from for a replace-
ment light bulb. Use only an original equipment light bulb from
your dealer or AGA MARVEL.
Do NOT under any circumstance use a light bulb that exceeds 25
watts!
To replace the light bulb, disconnect power to the unit. Unscrew
the old light bulb located behind the display housing at the top
of the unit. Set the old light bulb aside. Screw the new light
bulb into place. Reconnect power to the unit. Check to see if the
light bulb operates properly to complete the installation.
The light bulb is not covered by your warranty. A replacement
bulb can be obtained from your dealer or from AGA MARVEL.
Condenser is
behind toe grille
on left side of
cabinet
17
Figure 14
Toe grille screw
Toe grille (Front Grille)