Using Your Microsentry™ Refrigerator Control; Starting Your Refrigerator; Turning Your Refrigerator On Or Off; Set Temperature - AGA marvel 30ARM Installation, Operation And Maintenance Instructions

USING YOUR MICROSENTRY™ REFRIGERATOR CONTROL
Door Switch

Starting your refrigerator

Plug the refrigerator power cord into a wall outlet. Your refrig-
erator will begin cooling after power is applied.
If your refrigerator does not start, check that the refrigerator is
turned on and the set temperature is cold enough.

Turning your refrigerator ON or OFF

If the refrigerator is on, the refrigerator temperature will be
shown on the display. To turn the refrigerator off, press and hold
the "ON/OFF" button for three (3) seconds. "OFF" will appear on
the display.
If the refrigerator is off, "OFF" will be shown on the display. To
turn the refrigerator on, press and hold the "ON/OFF" button for
three (3) seconds. The refrigerator temperature will be shown on
the display.

Set temperature

To set the refrigerator temperature, press and hold the "SET"
button. When the "SET" button is pressed, the display will show
the set temperature. While holding the "SET" button, press the
"WARMER" or "COLDER" buttons to adjust set temperature.

Refrigerator operation

The available temperature range of the refrigerator is 33° to 45°
(1° to 7° C).
It may take up to 24 hours for your refrigerator to reach desired
temperature. This will depend on amount of content loaded and
number of door opening and closings.
For best results allow refrigerator to "pull down" to desired set
temperature before loading. Once contents are loaded, allow
at least 48 hours for temperature to stabilize before making any
adjustments to the set temperature.

Alarms

Your MicroSentry™ refrigerator control will monitor refrigerator
function and alert you with a series of audible and visual alarms.
Door Ajar Alarm: If the door has been left
•
open for over five (5) minutes, the alarm
will sound in one (1) second intervals. The
display panel will flash "do" and the Alarm LED located at the top
left of the display below the word "Alarm" will be a steady amber
color. This will stop as soon as the door is closed.
Temperature Sensor Fault: If the controller
•
detects that the temperature sensor is
not properly functioning, a temperature
sensor alarm will sound in one (1) second intervals. "E1" will
flash on the display panel and the Alarm LED located at the top
left of the display below the word "Alarm" will be a steady amber
color. Please call AGA MARVEL Customer Service or your dealer if
this error code is displayed.

Alarm Mute

Press any key to mute the audible portion of an alarm.
NOTE-This action will only mute the alarm. If the condition that
caused the alarm continues, the alarm code will continue to flash
and will sound for 20 seconds every 60 minutes.
6
Control
Figure 6