Care And Cleaning - AGA marvel MS24RD Installation, Operation And Maintenance Instructions

1) Current Interior Temperature (tI): While
tl is shown on the screen press and hold the
"SET" key to display the current interior tem-
perature.
2) Defrost Sensor Temperature (t2) refrig-
erator only: While t2 is shown on the screen
press and hold the "SET" key to display the
temperature of the defrost sensor.
3) Maximum Stored Temperature (thi): While
thi is shown on the screen, press and hold the
"SET" key to display the maximum recorded
temperature. The temperature is updated every 5 minutes.
To reset the maximum temperature; continue to hold the
SET key, then press and release the ON/OFF key to reset
the maximum temperature. The maximum temperature will
be reset to the current compartment temperature.
It is recommended that thi be reset after the initial pull-
down (24 hours after power on) to clear any residual
values.
4) Minimum Stored Temperature (tLO):
While tLo is shown on the screen, press and
hold the "SET" key to display the minimum
recorded temperature. The temperature is updated every
5 minutes. Continue to hold the SET key then, press and
release the ON/OFF key to reset the minimum temperature.
The minimum temperature will be reset to the current com-
partment temperature. It is recommended that tLo be reset
after the initial pull down (24 hours after power on) to clear
any residual values.
5) Firmware Version (FrM): While FrM is
shown on the screen press and hold the "SET"
key to display the version of the firmware.
6) Keypad Lockout Feature (Loc): This fea-
ture is used to prevent accidental changes to
the set temperature, or accidentally turning the unit off.
While Loc is displayed on the screen, press and hold the
SET key.
If "No" is displayed, Lockout feature is off,
and all keys are enabled. If "Yes"
played, Lockout feature is ON. The ability to turn the unit
on and off, as well as the ability to adjust set temperature
will be disabled. To change the keypad lockout setting,
continue to hold the SET key, then use the WARMER and
COLDER keys to set the desired value.

CARE AND CLEANING

• Never attempt to repair or perform maintenance on
the appliance until the main electrical power has been
disconnected. Turning the appliance control "OFF"
does not remove electrical power from the unit's wiring.
• Replace all parts and panels before operating.
Care and Cleaning
SHOCK HAZARD: Disconnect electrical power from the
appliance before cleaning with soap and water.
Front Grille
Periodically brush and vacuum the front grille area to main-
tain proper air flow through the condenser coil. See page 4,
Figure 2.
Cabinet
The painted cabinet can be washed with mild soap and
water and thoroughly rinsed with clear water. NEVER use
abrasive scouring cleaners.
Interior
Wash interior compartment with mild soap and water. DO
NOT use an abrasive cleaner, solvent, polish cleaner or
undiluted detergent.
Door Gasket
The vinyl gasket may be cleaned with mild soap and water,
a baking soda solution or a mild scouring powder.
In the Event of a Power Failure
is dis-
Minimize the number of door openings to prolong storage
temperature until power is restored.
Light assembly replacement
All models use an LED to illuminate the interior of the ap-
pliance. This component is very reliable, but should it fail,
contact a qualified service technician for replacement of the
LED.
11
WARNING
!
Electrocution Hazard
CAUTION
!