Energy Saving Tips; Care And Cleaning; Drawer Handle Installation - AGA marvel 6CRDE Installation, Operation And Maintenance Instructions

ENERGY SAVING TIPS, CARE AND CLEANING, AND

Energy Saving Tips

The following suggestions will minimize the cost of operat-
ing your refrigeration appliance.
1. Do not install your appliance next to a hot appliance,
(ovens, glassware washers, etc.). heating air duct, or
other heat sources.
2. Install product out of direct sunlight.
3. Assure the toe grille vents at front of unit beneath door
is not obstructed and kept clean to allow ventilation for
the refrigeration system to expel heat.
4. Plug your appliance into a dedicated power circuit. (Not
shared with other appliances).
5. When initially loading your new product, or whenever
large quantities of warm contents are placed within
refrigerated storage compartment, minimize door
openings for the next 12 hours to allow contents to pull
down to compartment set-point temperature.
6. Maintaining a relatively full storage compartment will
require less appliance run time than an empty compart-
ment.
7. Assure door closing is not obstructed by contents
stored in your appliance.
8. Allow hot items to reach room temperature before plac-
ing in product.
9. Minimize door openings and duration of door openings.
10. Use the warmest temperature control set-point that
provides the proper storage for your stored contents.
11. Set the control to the "off" position if cleaning the unit
requires the door to be open for an extended period of
time.
12. Periodically clean the front grille (toe kick) see page 4.

Care and Cleaning

Cabinet
The painted cabinet can be washed with either a mild soap
and water and thoroughly rinsed with clear water. NEVER
use abrasive scouring cleaners.
Interior
Wash interior compartment with mild soap and water. Do
NOT use an abrasive cleaner, solvent, polish cleaner or
undiluted detergent.
Care of Unit
1. Avoid leaning on the drawer fronts, you may bend the
drawer slides or tip the unit.
2. Exercise caution when sweeping, vacuuming or mop-
ping near the front of the unit. Damage to the grille can
occur.
3. Periodically clean the interior of the unit as needed.
4. Periodically check and/or clean the front grille as
needed.

DRAWER HANDLE INSTALLATION

Handle Installation (certain models)
1. Remove the handles, (4) screws, and
from the bag shipped inside the cabinet.
2. Locate handle centered on top of drawer and secure in
place using the (2) screws with the allen wrench. (See
Figure 9).
3. Repeat for other drawer.
Figure 9
9
⁄ " allen wrench
5
32
Screws
Handle