Table Of Contents; Before Your Start - RBI Dominator Series Installation & Operating Instructions Manual

If the information in this manual is not followed
exactly, a fire or explosion may result causing property,
personal injury or loss of life.
Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other applianc
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch. Do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
Assurez-vous de bien suivre les instructions données
dans cette notice pour réduire au minimum le risque
d'incendie ou d' e xplosion ou pour éviter tout dommoge
matériel, toute blessure ou la mort
Ne pas entreposer ni utiliser d'essence ou ni d'autres
vapeurs ou liquides inflammables à proximité de cet
appareil ou de tout autre appareil.
QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur; ne pas vous servir
des téléphones se trouvant dans le bâtiment.
• Appelez immédiatement votre fournisseur de gas depuis
un voisin. Suivez les intructions du fournisseur.
• Si vous ne purvez rejoindre le fournisseur, appelez le
service des incendies.
L'installation et l'entretien doivent être assurés par un
installateur ou un service d'entretien qualifié ou par le
fournisseur de gaz.
Failure to properly vent this unit can cause excessive
amounts of carbon monoxide resulting in severe
personal injury or death!
DESIGNED AND TESTED ACCORDING TO A.S.M.E.
BOILER AND PRESSURE VESSEL CODE, SECTION
IV FOR A MAXIMUM ALLOWABLE WORKING PRES-
SURE OF 160 PSI, 1103 kPa WATER.
2
F F Finned copper tube gas boilers & water heaters - Boiler Manual Fi d b b il & h B il M
BEFORE YOUR START . . . . . . . . . . . . . . . . PAGE 2
RATINGS & CAPACITIES . . . . . . . . . . . . . . . PAGE 3
BOILER/WATER HEATER LOCATION . . . . . . . . . PAGE 3
COMBUSTION AIR & VENTILATION . . . . . . . . . . PAGE 3
GENERAL VENTING GUIDELINES. . . . . . . . . . . PAGE 9
VENTING OPTIONS . . . . . . . . . . . . . . . . . . PAGE 9
VERTICAL/CHIMNEY VENTING . . . . . . . . . . . PAGE 10
OUTDOOR VENTING . . . . . . . . . . . . . . . . PAGE 11
COMMON VENT SYSTEMS . . . . . . . . . . . . . PAGE 12
GENERAL PIPING REQUIREMENTS . . . . . . . . PAGE 13
HEATING SYSTEM PIPING . . . . . . . . . . . . . PAGE 15
DOMESTIC WATER SUPPLY PIPING . . . . . . . . PAGE 18
GAS SUPPLY PIPING . . . . . . . . . . . . . . . . PAGE 22
ELECTRICAL WIRING . . . . . . . . . . . . . . . . PAGE 23
GENERAL OPERATION . . . . . . . . . . . . . . . PAGE 23
BOILER/WATER HEATER OPERATION . . . . . . . PAGE 24
OPERATING INSTRUCTIONS . . . . . . . . . . . . PAGE 28
CHECKING & ADJUSTMENTS. . . . . . . . . . . . PAGE 30
CONTROL DESCRIPTION . . . . . . . . . . . . . . PAGE 31
MAINTENANCE . . . . . . . . . . . . . . . . . . . PAGE 34
TROUBLE-SHOOTING . . . . . . . . . . . . . . . . PAGE 37
REPAIR PARTS . . . . . . . . . . . . . . . . . . . . PAGE 39
START UP FORM. . . . . . . . . . . . . . . . . . . PAGE 47
BEFORE YOU START
This manual covers the application, installation, operation and
maintenance of a Dominator Series finned copper heating boiler/
water heater/(pool heater- Canada only).
To obtain the safe, dependable, efficient operation and long life for
which this heating boiler/water heater was designed, these instruc-
tions must be read, understood and followed.
The Dominator Series finned copper heating boiler/water heaters
have been design certified by CSA for use with natural and propane
gas under the latest revision of ANSI-Z21.10.3/CSA 4.3, Gas Water
Heaters, and ANSI-Z21.13/CSA 4.9, Gas-Fired Low Pressure Steam
and Hot Water Boilers ANSI-Z21.56/CSA 4.7 Gas Fired Pool
Heaters (Canada only) and CAN 1-3.1 Industrial and Commercial
Gas Fired Packaged Boilers. Each unit has been constructed and
hydrostatically tested for a maximum working pressure of 160 psi,
1103 kPa in accordance with Section IV of the A.S.M.E. Boiler and
Pressure Vessel Code.
All aspects of the boiler/water heater installation must conform to
the requirements of the authority having jurisdiction, or, in the
absence of such requirements, to the National Fuel Gas Code, ANSI
Z223.1/NFPA 54-latest revision. Where required by the authority
having jurisdiction, the installation must conform to the Standard
for Controls and Safety Devices for Automatically Fired Boilers,
ANSI/ASME CSD-1.
l