Lamp Warning - Dukane 9137WU-RJ User Manual

Lamp (continued)

Lamp warning

HIGH VOLTAGE
WARNING ►The projector uses a high-pressure mercury glass lamp. The lamp
can break with a loud bang, or burn out, if jolted or scratched, handled while hot, or
worn over time. Note that each lamp has a different lifetime, and some may burst or
burn out soon after you start using them. In addition, if the bulb bursts, it is possible
for shards of glass to fly into the lamp housing, and for gas containing mercury and
dust containing fine particles of glass to escape from the projector's vent holes.
► About disposal of a lamp: This product contains a mercury lamp; do not put it
in a trash. Dispose of it in accordance with environmental laws.
· For lamp recycling, go to www.lamprecycle.org (in the US).
· For product disposal, consult your local government agency or www.eiae.org (in the
US) or www.epsc.ca (in Canada).
For more information, ask your dealer.
• If the lamp should break (it will make a loud bang when it does),
Unplug the power cord from the outlet, and make sure to request a
replacement lamp from your local dealer. Note that shards of glass could
damage the projector's internals, or cause injury during handling, so please
do not try to clean the projector or replace the lamp yourself.
• If the lamp should break (it will make a loud bang when it does), ventilate the
Disconnect the
plug from the
room well, and make sure not to inhale the gas or fine particles that come out
power outlet
from the projector's vent holes, and not to get them into your eyes or mouth.
• Before replacing the lamp, turn the projector off and unplug the power cord,
then wait at least 45 minutes for the lamp to cool sufficiently. Handling the
lamp while hot can cause burns, as well as damaging the lamp.
• Never unscrew except the appointed (marked by an arrow) screws.
• Do not open the lamp cover while the projector is suspended from a ceiling.
This is dangerous, since if the lamp's bulb has broken, the shards will fall out
when the cover is opened. In addition, working in high places is dangerous, so
ask your local dealer to have the lamp replaced even if the bulb is not broken.
• Do not use the projector with the lamp cover removed. At the lamp
replacing, make sure that the screws are screwed in firmly. Loose screws
could result in damage or injury.
• Use only the lamp of the specified type. Use of a lamp that does not meet
the lamp specifications for this model could cause a fire, damage or shorten
the life of this product.
• If the lamp breaks soon after the first time it is used, it is possible that there
are electrical problems elsewhere besides the lamp. If this happens, consult
your local dealer or a service representative.
• Handle with care: jolting or scratching could cause the lamp bulb to burst
during use.
• Using the lamp for long periods of time, could cause it dark, not to light up
or to burst. When the pictures appear dark, or when the color tone is poor,
please replace the lamp as soon as possible. Do not use old (used) lamps;
this is a cause of breakage.
HIGH TEMPERATURE
10
HIGH PRESSURE